Zum Inhalt springen

WSAL23104 – Raspberry Pi Pico W/en

Aus JW Tech Wiki

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The Raspberry Pi Pico W is the wireless successor to the standard Pico. It uses the RP2040 dual-core processor designed by Raspberry Pi and adds an integrated 2.4 GHz Wi-Fi chip (Infineon CYW43439). The board provides 26 multi-function GPIOs, a USB 1.1 port with device and host support, and drag-and-drop programming via mass storage over USB.

Related products at JW Tech

Technical overview

  • RP2040: dual-core Arm Cortex-M0+, clock up to 133 MHz
  • 264 KB SRAM and 2 MB onboard Flash memory
  • Infineon CYW43439: 2.4 GHz Wi-Fi
  • 26 multi-function GPIO pins
  • 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 PWM channels
  • 8 programmable PIO state machines for custom peripherals
  • On-chip temperature sensor
  • Castellated module form factor: contact pads for direct soldering onto carrier boards
  • USB 1.1: supports both device and host modes
  • Low-power sleep and dormant modes

Notes and version constraints

  • No explicit commands or CLI instructions are present in the source; do not invent command syntax.
  • Exact pinout details are only referenced, not reproduced – verify against the original source documents.
  • Version-sensitive steps (firmware updates, MicroPython/SDK setup) require human confirmation since they depend on the specific software version in use.
  • The source contains template placeholders ({{{name2}}} etc.), indicating incomplete templates – full specifications should be cross-checked against official datasheets.
  • No pricing, stock, certification, or warranty information appears in the source; such claims must not be invented.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL23104_–_Raspberry_Pi_Pico_W/en&oldid=2426“