Zum Inhalt springen

WSAL11502 – 10.1inch HDMI LCD (H) (with case)/en

Aus JW Tech Wiki

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

Concise technical wiki for the Waveshare 10.1-inch capacitive touch LCD (H), resolution 1024×600. Covers interfaces, Raspberry Pi setup, PC usage, control keys and known limitations.

Related products at JW Tech

Technical overview

  • The display has a native resolution of 1024 × 600 pixels and features a capacitive touch panel.
  • Main control board interfaces: HDMI, VGA, and AV (CVBS) video inputs; a Micro USB port is used for communication/control.
  • When using a Raspberry Pi, write the official OS image to a TF card and append hdmi_group=2, hdmi_mode=87, and hdmi_cvt 1024 600 60 6 0 0 0 to config.txt.
  • The main control board connects to the display via a 40-pin FFC cable; contacts face down at the RGB connector. The hardware supports LVDS but no LVDS firmware is provided.
  • Power requirements: 12 V / 1 A adapter for the main control board; the Raspberry Pi needs 5 V / 2.5 A (5 V / 3 A recommended if high-load devices such as a camera are attached).
  • After powering on, the upper-left corner shows the active signal source; use the Source key to switch between HDMI, VGA, or AV as needed.
  • If touch behaves abnormally under Linux, run the commands listed in the source to restore normal input behavior.
  • Under Windows, touch works through mouse emulation, so touch coordinates do not adjust when the screen is rotated.

Commands and examples – verify before use:  

hdmi_group=2
hdmi_mode=87
hdmi_cvt 1024 600 60 6 0 0 0
sudo apt-get install xserver-xorg-input-evdev
sudo mv /usr/share/X11/xorg.conf.d/40-libinput.conf /usr/share/X11/xorg.conf.d/40-libinput.conf_bak
reboot

Notes and version constraints

  • The exact size of the main control board is not stated in the source; confirm with the manufacturer.
  • LVDS toolchain: Hardware supports LVDS, but no firmware is available – operate via RGB/FFC only.
  • Windows touch rotation issue: This model uses mouse-emulation; for correct coordinates after rotation, the (F) model is recommended instead.
  • Power supply specification: Use only the voltage/current values given in the source; do not assume other adapters are compatible.
  • Commands are version-sensitive: The Linux commands assume specific package versions; verify the environment before running them.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL11502_–_10.1inch_HDMI_LCD_(H)_(with_case)/en&oldid=1542“