Quelltext der Seite WSAL22383 – Zero-to-Pi3-Adapter (B)/en

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The Waveshare Zero-to-Pi3 Adapter (B) allows a Raspberry Pi Zero 2W to be used on a board with the same interfaces as the Raspberry Pi 3 Model B/B+. It provides four USB ports, an Ethernet connection via an RJ45 port, and an HDMI output. It is designed exclusively for the Zero 2W; the older Zero is not supported.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL22383 WSAL22383 – Raspberry Pi Zero 2W To 3B Adapter, Alternative Solution for Raspberry Pi 3 Model B/B+]

== Technical overview ==
* Base module: Raspberry Pi Zero 2W featuring a Broadcom BCM2710A1 quad-core SoC (Arm Cortex-A53 @ 1 GHz), 512 MB LPDDR2 SDRAM, 2.4 GHz 802.11b/g/n Wi-Fi, and Bluetooth 4.2 with BLE.
* Connection: Pogo pins plug directly into the Zero board, allowing it to mount without a connector.
* Interfaces: Four USB 2.0/1.1 expansion ports, one RJ45 Ethernet port (10/100 Mbps using an RTL8152B chip), mini-HDMI output, micro-USB OTG port, microSD slot, 40-pin GPIO header, composite video pads, and reset pad.
* Camera: CSI-2 camera interface available.
* Media: H.264/MPEG-4 codec support at 1080p30, plus OpenGL ES 1.1/2.0 graphics.
* Compatibility: Supports only the Raspberry Pi Zero 2W; the original Raspberry Pi Zero is explicitly unsupported.
* Mechanical: Thread size PM2.5*4 for screwing the Pi onto the adapter.
* Audio: Onboard USB audio headphone jack and additional speaker port.
* Documentation: Schematic, Zero 2W datasheet, dimensions, and test introduction are linked in the resources section.
* Software tools: Panasonic SD Formatter, Win32DiskImager, and PuTTY are mentioned as useful utilities.

'''Commands and examples – verify before use:''' 
<syntaxhighlight lang="text">
dtoverlay=dwc2,dr_mode=host
</syntaxhighlight>

== Notes and version constraints ==
* Compatibility applies only to the Zero 2W; the older Zero does not work with this adapter.
* The Zero 2W's USB interface differs from the original Zero. If the mouse or keyboard stop responding, add the line `dtoverlay=dwc2,dr_mode=host` to /boot/config.txt.
* Version-sensitive steps: The exact firmware/driver versions of the Zero 2W and the adapter should be confirmed before setup; the document does not state specific version numbers.
* Adapter dimensions are not fully given in the provided text (only a link to the dimensions data).
* No prices, stock levels, warranties, or safety certifications are mentioned in the source; these must not be added.

== Source and revision record ==
* [https://www.waveshare.com/wiki/Zero-to-Pi3-Adapter_(B) Zero-to-Pi3-Adapter (B) - Waveshare Wiki]
* Source revision: 89702
* Captured: 2026-09-03T03:57:07+00:00
* SHA-256: <code>ccd785a107064d97f4eb60887f8b0cf298d405dd2fbebaf2b157a9540ae2761f</code>