Quelltext der Seite WSAL21474 – Pico-BLE/en

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The Waveshare Pico-BLE (WSAL21474) is a dual-mode Bluetooth module supporting SPP and BLE, controlled via UART AT commands.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL21474 WSAL21474 – Dual-Mode Bluetooth Module for Raspberry Pi Pico, SPP / BLE, Bluetooth 5.1]

== Technical overview ==
* Dual-mode Bluetooth 5.1 module for the Raspberry Pi Pico series.
* Communication over UART; example code uses 115200 baud by default.
* Dimensions approx. 56.5 × 21 mm; operating voltage 3.3 V or 5 V.
* Connects via standard Pico header; UART0 on pins TX=0, RX=1; status pin on pin 15.
* V1.1 (purchased after 2022/02/20) additionally supports connection to a Raspberry Pi via rfcomm.
* C example code implements initialization, command processing, and transparent data forwarding.
* Commands are sent over UART; carriage return + line feed at end of line is required, otherwise commands are invalid.
* For mobile devices: When using the BLE protocol, the notify function must be enabled in the app.

'''Commands and examples – verify before use:''' 
<syntaxhighlight lang="text">
AT+RESET (Zurücksetzen des Moduls)
bluetoothctl (Interaktiver Modus)
show (Statusanfrage: powered / discoverable / pairable)
scan on (Suche nach Geräten)
pair [MAC] (Paarung mit Gerät)
sudo rfcomm conn /dev/rfcomm0 [MAC] (SPP-Verbindung)
echo 1234541 > /dev/rfcomm0 (Daten senden)
cat /dev/rfcomm0 (Daten lesen)
</syntaxhighlight>

== Notes and version constraints ==
* Only slave mode is available – no host mode.
* V1.0 can currently only pair with mobile devices; Raspberry Pi support starts from V1.1 (purchased after 2022/02/20).
* CR+LF line ending is mandatory for AT commands; otherwise they will not be processed.
* Using MicroPython firmware for Pico2 may cause recognition issues; use the recommended firmware from the package.
* The exact AT commands beyond the reset command are not fully listed in the source text – please consult the user manual.

== Source and revision record ==
* [https://www.waveshare.com/wiki/Pico-BLE Pico-BLE - Waveshare Wiki]
* Source revision: 91316
* Captured: 2026-09-03T02:55:04+00:00
* SHA-256: <code>8ffaa255126124c8abc4962b23363869cea8d746699cdab7633e3f453919166b</code>