Quelltext der Seite WSAL20265 – PL2303 USB UART Board V2/en

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The PL2303 USB-to-UART (TTL) communication module (V2) converts USB to a serial interface and supports 1.8 V, 2.5 V, 3.3 V and 5 V logic levels via jumper settings. It uses the newer PL2303GS chip, provides three status LEDs (TXD, RXD, PWR), and is compatible with Windows XP/7/8/10/11.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL20265 WSAL20265 – PL2303 USB To UART (TTL) Communication Module, Micro / Mini / Type A / Type C Connector]
* [https://shop.jw-tech.eu/p/WSAL20645 WSAL20645 – PL2303 USB To UART (TTL) Communication Module, Micro / Mini / Type A / Type C Connector]
* [https://shop.jw-tech.eu/p/WSAL24680 WSAL24680 – PL2303 USB To UART (TTL) Communication Module, Micro / Mini / Type A / Type C Connector]
* [https://shop.jw-tech.eu/p/WSAL24681 WSAL24681 – PL2303 USB To UART (TTL) Communication Module, Micro / Mini / Type A / Type C Connector]

== Technical overview ==
* Chipset: PL2303GS (newer revision of PL2303).
* Interfaces: USB on the host side, UART (TTL) on the device side.
* USB supply voltage: 5 V.
* Selectable UART logic levels: 1.8 V / 2.5 V / 3.3 V / 5 V via jumpers.
* VCCIO jumper modes: 5 V external power; 3.3 V external power; without jumper cap, powered by an external supply.
* Board dimensions: 16.51 mm × 48.26 mm.
* Three onboard LEDs: TXD, RXD, PWR.
* Supported operating systems: Windows XP, 7, 8, 10, 11.
* Available resources: schematic, drivers (Windows/Linux), Serial Debugging Assistant, PuTTY, PL2303 driver program.
* Available datasheets: PL2303, PL2303TA, PL2303GS.

== Notes and version constraints ==
* No commands are specified in the source document – no exact commands derived.
* Exact jumper positions for each mode are not detailed; consult the original schematic before changing jumpers.
* Linux drivers must be installed manually; the document only lists “PL2303G Linux driver” without installation instructions.
* No warranty, certification, or pricing information is present – no assumptions made.
* Version-sensitive steps (e.g., exact jumper configuration) require human confirmation against the current schematic.

== Source and revision record ==
* [https://www.waveshare.com/wiki/PL2303_USB_UART_Board_V2 PL2303 USB UART Board V2 - Waveshare Wiki]
* Source revision: 90291
* Captured: 2026-09-02T03:36:59+00:00
* SHA-256: <code>94a4dcf97d3426e395eaf832dac80b2da15f1628343ed9ab6e9caf18bf63751b</code>