Zum Inhalt springen

WSAL17855 – Jetson Nano Case (C)/en

Aus JW Tech Wiki

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The Waveshare Jetson Nano Metal Case (C) is an enclosed enclosure with an internal fan design and camera holder. It provides protection, cooling, and camera mounting for the Nvidia Jetson Nano Developer Kit.

Related products at JW Tech

Technical overview

  • Inspect all components before assembly.
  • Mount buttons on the metal box: the four-wire button is Power, the two-wire button is Reset.
  • Insert the micro SD adapter board into the Jetson Nano card slot and press until it locks.
  • Route cables, mount the Jetson Nano Developer Kit inside the metal box and secure it with screws.
  • Secure the micro SD adapter board with a screw.
  • Fix the GPIO adapter board to the metal box using skews.
  • Attach the wireless module antennas to the metal box and assemble the cooling fan.
  • Mount the bottom camera holder on the metal cover, attach the camera to the top holder with nylon screws, adjust the angle, and tighten.
  • Dimensions: 13.2 cm (L) x 10.2 cm (W) x 5.5 cm (H).
  • Enable DC power by shorting the J48 interface with a jumper cap, then plug the DC supply into the circular power connector.

Notes and version constraints

  • For older A02 development kit version: connect the POWER button only to the key pin; leave the LED light pin unconnected.
  • If you purchased a Jetson Nano DEV KIT, the TF card adapter board does not apply; insert the TF card directly into the bottom board's card slot. The adapter board is only suitable for the official Nvidia kit.
  • When removing the adapter board, press it first so it pops up, then pull it out. Do not pull it out directly, as this can damage the card slot.
  • If using only one camera, connect just one cable.
  • Assembly steps may vary by hardware revision; verify your exact kit version before proceeding if uncertain.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL17855_–_Jetson_Nano_Case_(C)/en&oldid=2036“