Zum Inhalt springen

WSAL24101 – 0.96inch OLED Module/en

Aus JW Tech Wiki
Version vom 6. September 2026, 09:56 Uhr von JWTechPublisher (Diskussion | Beiträge) (Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The 0.96-inch OLED module uses the SSD1315 driver, supports 4-wire SPI and I2C, has a 128×64 pixel resolution, and is powered via VCC at 3.3 V or 5 V.

Related products at JW Tech

Technical overview

  • Resolution: 128 × 64 pixels
  • Driver IC: SSD1315
  • Interfaces: 4-wire SPI and I2C
  • Supply voltage: 3.3 V or 5 V at VCC; IO high-level voltage matches the supply voltage
  • Housing dimensions: 26.0 mm × 26.0 mm; active display area: 21.74 mm × 11.18 mm
  • Operating temperature: −20 °C to 70 °C; storage temperature: −30 °C to 80 °C
  • Viewing angle: greater than 160°
  • Color variants: Blue, White, Yellow/Blue (top quarter yellow area)
  • I2C address selection via resistors R1/R2 on the back: R1 = 0 Ω for SPI, R2 unpopulated; R2 = 0 Ω gives I2C address 0x3C, R2 open gives 0x3D
  • Raspberry Pi connection via 7-pin cable: DIN→MOSI/SDA (pin 19/3), CLK→SCLK/SCL (pin 23/5), CS→CE0 (pin 24), DC→pin 25, RES→pin 27
  • For Raspberry Pi, the SPI or I2C interface must be enabled via “raspi-config → Interfacing Options”, then reboot
  • Available libraries for Raspberry Pi: BCM2835, WiringPi, and lgpio; under Bookworm only lgpio is usable
  • C demo invocation: “sudo ./main 0.96” in the “c” directory after compiling with “sudo make -j 8”
  • Python demo invocation: “sudo python3 OLED_0in96_test.py” in the “python/example” directory

Commands and examples – verify before use:  

sudo raspi-config
sudo reboot
sudo make clean
sudo make -j 8
sudo ./main 0.96
sudo python3 OLED_0in96_test.py

Notes and version constraints

  • The exact hardware configuration (R1/R2) depends on the desired interface; when switching to I2C, R2 must be populated or removed accordingly
  • When using STM32, the I2C demo uses the analog I2C interface – wiring must be checked carefully
  • Do not display the same screen for extended periods to avoid burn-in (residual images)
  • Be careful with power polarity: do not reverse the power connection
  • Under the Bookworm operating system, BCM2835 and WiringPi are unavailable; only lgpio works
  • Compatibility with specific Raspberry Pi generations and kernel versions is not fully specified in the source

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL24101_–_0.96inch_OLED_Module/en&oldid=2801“