WSAL22224 – 1.47inch LCD Module/en
Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.
Summary
Technical guide for the 1.47-inch LCD module with ST7789V3 controller, SPI connection and examples for Raspberry Pi, STM32 and Arduino.
Related products at JW Tech
Technical overview
- Resolution: 172 x 320 pixels; IPS type
- Supply voltage: 3.3 V or 5 V; supply and logic voltages must match
- Interface: 4-wire SPI; ST7789V3 supports RGB444/RGB565/RGB666 color formats
- Connection to Raspberry Pi via PH2.0 8-pin cable per pin mapping table
- Example programming for STM32F103RBT6 with provided pin mapping
- Arduino UNO pin mapping available
- SPI mode 0 (CPHA=0, CPOL=0) is commonly used
- Python demos run without additional library installation on Bookworm
Commands and examples – verify before use:
sudo raspi-config
sudo reboot
sudo ./main 1.47
sudo python3 1inch47_LCD_test.py
Notes and version constraints
- Pin mappings are device-specific; adapt them for other boards
- The FBCP porting replaces /boot/config.txt and /etc/rc.local - back them up first
- Version-sensitive steps: BCM2835/wiringPi are unavailable on Bookworm, only lgpio
- Maximum brightness 380 cd/m² and current draw 47 mA apply at 3.3 V only
Source and revision record
- 1.47inch LCD Module - Waveshare Wiki
- Source revision: 100991
- Captured: 2026-09-03T03:44:10+00:00
- SHA-256:
f70c35f262654c61f8434998cfe8081336170bcd95a58ae1372272f0bb38525a