WSAL23414 – RGB-5050-5V-IP65-60D-1M/en
Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.
Summary
The RGB-5050-5V-IP65-60D-1M is a 1 m water-resistant (IP65) RGB LED strip using WS2812B chips. It runs at 5 V, contains 60 LEDs per meter and uses a single-wire channel with return-to-zero coding.
Related products at JW Tech
Technical overview
- Light source: 5050 LEDs, 60 per meter, 120° beam angle
- Controller chip: WS2812B, 24-bit data word per LED (R, G, B each 8 bits)
- Supply voltage: 5 V; maximum current draw approx. 3.6 A/m at full brightness
- Ingress protection: IP65 (splash-proof), operating temperature range -25 to 80 °C
- Connector: 3-pin PH2.0 header – red = VCC, green = DATA (input/output), white = GND
- Protocol: single-wire bus, return-to-zero code; after receiving 24 bits the DO output forwards data to the next chain element
- Timing values: T0H ≈ 0.35 µs, T1H ≈ 1.36 µs, T0L ≈ 1.36 µs, T1L ≈ 0.35 µs, RESET ≥ 50 µs
- Sample demos available for Raspberry Pi (default pin D18) and Pico (default pin GPIO7)
Notes and version constraints
- The source lists no concrete command strings or API calls; therefore the commands field remains empty.
- When cascading multiple strips, the source recommends adding a power feed every 300 lights – exact design depends on total length.
- The stated timing tolerances (±150 ns) are tight; MCU implementations must reliably meet this accuracy.
- The source references external demo examples (Pico/Raspberry Pi); whether these still work requires manual confirmation.
- No information on certifications, warranty or price in the source – such details were intentionally omitted.
Source and revision record
- RGB-5050-5V-IP65-60D-1M - Waveshare Wiki
- Source revision: 74777
- Captured: 2026-09-04T02:55:54+00:00
- SHA-256:
48790edca228aaab0c0c7f2387dcd2c7965da761b992911b8e011436edd8c679