Zum Inhalt springen

WSAL18490 – PiRacer Pro AI Kit/en

Aus JW Tech Wiki
Version vom 6. September 2026, 00:42 Uhr von JWTechPublisher (Diskussion | Beiträge) (Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The PiRacer Pro is a high-performance AI racing robot kit for the Raspberry Pi. The expansion board integrates an OLED, servo drive and battery protection circuitry; no soldering required.

Related products at JW Tech

Technical overview

  • Powered by a Raspberry Pi 4 (not included in the kit).
  • Supports four 2600 mAh 18650 batteries (not included); two in parallel and two in series to increase motor power output.
  • On-board HY2120 + AOD514 lithium battery protection circuit with overcharge, over-discharge, overcurrent and short-circuit protection.
  • On-board FP5139 automatic buck-boost voltage regulator provides stable 5 V to the Raspberry Pi.
  • 0.91-inch 128 × 32 OLED displays IP address, memory and power status in real time.
  • AINA219 chip enables real-time monitoring of battery voltage and charging current.
  • Fully compatible with the DonkeyCar open-source project; supports deep learning, autonomous driving and automatic visual inspection.
  • Chassis upgrades include front/rear axle differential lock, hydraulic shock absorbers, four-wheel drive with independent suspension, carbon-fiber chassis and high-speed brush motors.

Notes and version constraints

  • The Raspberry Pi 4 is not included in the kit and must be sourced separately.
  • The 18650 batteries are also not included; four units are required.
  • Exact compatibility with specific Raspberry Pi models or software versions should be verified before purchase.
  • Building and configuring the DonkeyCar project requires additional steps on a Linux PC.
  • The provided source contains placeholders ({{{...}}), suggesting incomplete or outdated content; some details may be uncertain.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL18490_–_PiRacer_Pro_AI_Kit/en&oldid=2072“