Zum Inhalt springen

WSAL18096 – 10.1inch HDMI LCD (E)/en

Aus JW Tech Wiki
Version vom 6. September 2026, 00:40 Uhr von JWTechPublisher (Diskussion | Beiträge) (Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The Waveshare 10.1-inch capacitive touch LCD (E) provides a 1024×600 resolution on an IPS panel with optical bonding and 10-point touch. It is usable as an HDMI monitor and supports Raspberry Pi, Jetson Nano, and PC environments.

Related products at JW Tech

Technical overview

  • Resolution: 1024 × 600 pixels
  • IPS panel with optically bonded display for improved touch response
  • Tempered glass panel rated 6H hardness with 10-point capacitive touch
  • Supported systems: Raspberry Pi OS, Ubuntu, Kali, Retropie; Windows 11/10/8.1/8/7
  • Interfaces: USB (touch), HDMI (video/audio), 3.5 mm jack and 4-pin audio header
  • Backlight can be switched off via side button to save power
  • Active display area: 222.72 mm (H) × 125.28 mm (V)
  • Operating temperature range: 0–70 °C
  • Operating current at 5 V supply: approximately 750–900 mA
  • Side buttons: Power (backlight), Menu/OSD, Up/Left, Down/Right, Exit

Commands and examples – verify before use:  

hdmi_group=2
hdmi_mode=87
hdmi_cvt 1024 600 60 6 0 0 0
disable_splash=1
vcgencmd display_power 0
vcgencmd display_power 1
gpioc -g pwm 18 0
gpioc -g mode 18 pwm
gpioc pwmc 1000
gpioc -g pwm 18 X

Notes and version constraints

  • The exact config.txt lines are version-sensitive; verify compatibility with the installed Raspberry Pi OS before applying them.
  • PWM backlight control requires removing a resistor and soldering the upper pad to Raspberry Pi pin P1 – this step involves hardware modification.
  • The listed gpioc commands rely on the 'gpio' utility; it may not be preinstalled on every system image.
  • When multiple monitors are connected simultaneously, this LCD should be set as the primary screen so that it controls the cursor.
  • An external power adapter may be needed if the host (PC or Raspberry Pi) cannot fully power the display.
  • The stated operating current (750–900 mA) refers to normal operation; inrush currents at startup may be higher.
  • No information on certifications, warranty, or safety approvals was present in the source – these require separate confirmation.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL18096_–_10.1inch_HDMI_LCD_(E)/en&oldid=1994“