Zum Inhalt springen

WSAL19884 – ZED-F9P GPS-RTK HAT/en

Aus JW Tech Wiki
Version vom 6. September 2026, 00:37 Uhr von JWTechPublisher (Diskussion | Beiträge) (Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The ZED-F9P GPS-RTK HAT is a precision GNSS module with RTK capability that connects to a Raspberry Pi via UART. It supports multiple satellite systems and frequency bands, enables centimeter-level accuracy in RTK mode, and can operate as either a rover or a base station.

Related products at JW Tech

Technical overview

  • Supported signals: GPS, SBAS, QZSS, GLONASS, BeiDou, Galileo
  • Frequency bands: GPS L1C/A and L2C, SBAS, QZSS, GLONASS L1OF/L2OF, BeiDou B1I/B2I, Galileo E1B/C/E5b
  • Positioning accuracy: <1.5 m CEP (PVT) or 0.01 m + 1 ppm CEP (RTK)
  • Acquisition time: cold start up to 24 s, hot start ~2 s
  • Acquisition sensitivity: -148 dBm; tracking sensitivity: -167 dBm
  • Update rate: up to 25 Hz in RTK mode, default 1 Hz
  • Interfaces: UART, SPI, I2C, USB
  • Operating voltage: 5 V via the 5V pin; current draw under 120 mA at 5 V

Commands and examples – verify before use:  

mkdir zed-f9p && cd zed-f9p
wget https://files.waveshare.com/upload/d/d4/ZED-F9P_GPS-RTK_HAT_Code.zip
unzip ZED-F9P_GPS-RTK_HAT_Code.zip
cd python
sudo pip3 install pynmeagps
sudo python3 main.py -u psi_user -p psi -2 landsd-gncaster.realtime.data.gov.hk 2101 T430_32

Notes and version constraints

  • The demo commands use test credentials from a specific NTRIP service; other regions require their own account details.
  • For Windows PC usage, u-center must be installed; the exact steps depend on the chosen base-station provider.
  • The “Moving Base and Rover” section lacks configuration details for the MB module; additional information from the full manual is needed.
  • The listed commands assume the hardware serial port has been enabled on the Raspberry Pi.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL19884_–_ZED-F9P_GPS-RTK_HAT/en&oldid=1806“