Zum Inhalt springen

WSAL16446 – 2.8inch Resistive Touch LCD/en

Aus JW Tech Wiki
Version vom 6. September 2026, 00:34 Uhr von JWTechPublisher (Diskussion | Beiträge) (Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)

Documentation notice: This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

Summary

The 2.8-inch IPS LCD with a resistive touch panel provides 320 × 240 pixels and communicates via a 4-wire SPI bus. The display driver defaults to ST7789; HX8347D is the alternative. The XPT2046 touch controller supports 12-bit ADC at 125 kHz sampling and also provides temperature and battery-voltage measurements.

Related products at JW Tech

Technical overview

  • Display resolution: 320 × 240 pixels, IPS panel, 65K colors (RGB).
  • Interface: 4-wire SPI with CPHA=0, CPOL=0; data transmitted MSB-first.
  • Default driver ST7789; switch to HX8347D by editing the defines on lines 80/81 of LCD_Driver.h if the display does not render.
  • Touch controller XPT2046: 12-bit ADC at 125 kHz, I/O range 1.5–5.25 V, on-chip temperature sensor, battery monitoring 0–5 V.
  • Dimensions: overall 79.9 mm × 50.8 mm, active display area 57.6 mm × 43.2 mm.
  • Power: 5 V for the panel, 3.3 V logic level; LED backlight with programmable control via LCD_BL.
  • Pins: 5V, GND, MISO, MOSI, SCLK, LCD_CS, LCD_DC, LCD_RST, LCD_BL, TP_CS, TP_IRQ.
  • Compatible with OpenX05R-C, OpenM128, Open103C, and PIC-based boards (Open16F877A / Open18F4520); pin mappings differ per board.
  • Touch calibration is performed with a stylus after launching the demo; drawing becomes possible afterwards.

Commands and examples – verify before use:  

#define ST7789_DEVICE  // Zeile 80 in LCD_Driver.h (standardmäßig aktiv)
//#define HX8347_DEVICE  // Zeile 81 in LCD_Driver.h (kommentiert aus, aktivieren zum Umschalten)

Notes and version constraints

  • Driver switching requires editing LCD_Driver.h; exact line numbers may vary by firmware version.
  • Demo projects are tied to specific development boards; verify correct pin mapping before flashing.
  • Calibration is version-sensitive: if calibration fails, the driver or firmware may need updating.
  • No warranty, certification, or safety-compliance information is present in the source; these must be verified separately.

Source and revision record

Abgerufen von „https://wiki.jw-tech.eu/index.php?title=WSAL16446_–_2.8inch_Resistive_Touch_LCD/en&oldid=1682“