Quelltext der Seite WSAL20129 – Pico-ePaper-7.5-B/en

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The Waveshare Pico e-Paper 7.5 B is a 7.5-inch e-paper display module with 800×480 pixels and a tri-color red/black/white output mode, connected to a Raspberry Pi Pico via an SPI interface.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL20129 WSAL20129 – 7.5inch E-Paper E-Ink Display Module (B) for Raspberry Pi Pico, 800×480, Red / Black / White, SPI]

== Technical overview ==
* Resolution: 800 × 480 pixels; screen diagonal: 7.5 inches
* Display colors: black, white, red (tri-color mode)
* Interface: SPI, operating voltage 3.3 V
* Full refresh takes approximately 16 s; flickering during the global refresh is normal
* Refresh power: 48 mW typical; standby current &lt; 0.01 µA
* Pico pinout: DIN→GP11, CLK→GP10, CS→GP9, DC→GP8, RST→GP12, BUSY→GP13, VCC→VSYS, GND→GND
* Pixel data are stored as one byte per 8 pixels; in tri-color mode two bit-planes are required: a black/white plane and a red/white plane
* Demo code can be downloaded via wget or git clone and compiled/run under C/C++, MicroPython or Arduino

'''Commands and examples – verify before use:''' 
<syntaxhighlight lang="text">
cd ~ && sudo wget https://files.waveshare.com/upload/5/5a/Pico_ePaper_Code.zip && unzip Pico_ePaper_Code.zip -d Pico_ePaper_Code && cd ~/Pico_ePaper_Code
cd ~ && git clone https://github.com/waveshare/Pico_ePaper_Code.git && cd ~/Pico_ePaper_Code
mkdir build && cd build && export PICO_SDK_PATH=../../pico-sdk && cmake -DPICO_BOARD=pico -DPICO_PLATFORM=rp2040 .. && make -j9
cp epd.uf2 /media/pi/RPI-RP2/
sudo apt upgrade thonny
git clone https://github.com/waveshare/Pico_ePaper_Code.git
</syntaxhighlight>

== Notes and version constraints ==
* The stated 16 s refresh time is experimental test data; actual times may vary
* When waking from deep sleep, the first refresh may show afterimages; clear the screen before refreshing
* If the program gets stuck in the busy state: check wiring and verify SPI parameters (baud rate, mode)
* After entering deep sleep, the module must be re-initialized before it can be refreshed again
* The display border color can be adjusted via the Border Waveform Control register or the VCOM AND DATA INTERVAL SETTING register
* Power consumption figures are lab measurements; real-world values may differ depending on driver board and usage conditions

== Source and revision record ==
* [https://www.waveshare.com/wiki/Pico-ePaper-7.5-B Pico e-Paper 7.5 B - Waveshare Wiki]
* Source revision: 69264
* Captured: 2026-09-02T03:20:57+00:00
* SHA-256: <code>2dd21c5b2a771c65039a2f3c0bfbf29139ed5245f925eac9718c1ec02758c837</code>