JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

2026-09-05T22:35:22Z

Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

Neue Seite

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
Technical data sheet and setup guide for the SIM7600G-H-PCIE (Waveshare/SIMCom): frequency bands, interfaces, power supply, indicators, Raspberry Pi setup via Minicom, and selected AT commands.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL19543 WSAL19543 – SIM7600G-H-PCIE SIMCom Original 4G LTE Cat-4 Module, Global Coverage, GNSS, Mini-PCIe Connector]

== Technical overview ==
* M.2 B Key form factor; dimensions 42.0 × 31.4 × 3.8 mm; operating temperature −40 °C to +85 °C.
* Power supply 3 V to 4.2 V; approximately 4.0 V recommended for proper operation.
* LTE-FDD bands: B1, B2, B3, B4, B5, B7, B8, B12, B13, B18, B19, B20, B25, B26, B28, B66.
* LTE-TDD bands: B34, B38, B39, B40, B41; WCDMA: B1, B2, B4, B5, B6, B8, B19; GSM: 850/900/1800/1900 MHz.
* GNSS: GPS, Beidou, GLONASS, GALILEO, QZSS; antenna connectors IPEX-4 (LTE main, LTE diversity, and GNSS antenna).
* Data rates: LTE 150 Mbps downlink / 50 Mbps uplink; HSPA+ 42/5.76 Mbps; WCDMA 384 Kbps; EDGE 236.8 Kbps; GPRS 85.6 Kbps.
* Interfaces: UART, USB, GPIO; supported OSes Windows/Linux/Android; protocols TCP/IP/IPv4/IPv6/Multi-PDP/FTP/FTPS/HTTP/HTTPS/DNS; SMS MT/MO/CB/Text/PDU; firmware update via USB/FOTA.
* STA/NET LED states: both off = powered off; both on = operating; STA on, NET blinking = no SIM or weak signal; NET blinking/on during shutdown = shutting down.
* Raspberry Pi setup: install minicom, open /dev/ttyUSB2, run AT+CUSBPIDSWITCH=9011,1,1, then sudo dhclient -v usb0 for RNDIS data access.
* AT commands cover test, echo, manufacturer/type/SN/firmware version checks, signal quality (AT+CSQ), SIM status (AT+CPIN?), network status (AT+CREG?, AT+COPS?), and network mode selection (AT+CNMP).

'''Commands and examples – verify before use:'''
<syntaxhighlight lang="text">
AT
ATE0
ATE1
AT+CGMI
AT+CGMM
AT+CGSN
AT+CSUB
AT+CGMR
AT+IPREX
AT+CRESET
AT+CSQ
AT+CPIN?
AT+COPS?
AT+CREG?
AT+CPSI?
AT+CNMP
AT+CUSBPIDSWITCH=9011,1,1
AT+CNBP=0x0002000000400183,0x000001E000000000,0x0000000000000021
AT+CNBP=0x0002000000400180,0x480000000000000000000000000000000000000000000042000001E200000095,0x0000000000000021
</syntaxhighlight>

== Notes and version constraints ==
* M.2 B Key is not compatible with MINI-PCIe connectors – verify the interface before use.
* Do not plug in the module while it is powered.
* If the module does not connect normally after successful setup: try one of the two AT+CNBP commands to change the frequency.
* The exact return values of AT+CSQ, AT+COPS? and AT+CREG? are given only as placeholders in the source; actual values must be read from the device.
* Version-sensitive steps and driver installation may vary by OS version; human confirmation required when uncertain.

== Source and revision record ==
* [https://www.waveshare.com/wiki/SIM7600G-H-PCIE SIM7600G-H-PCIE - Waveshare Wiki]
* Source revision: 77702
* Captured: 2026-09-01T04:29:19+00:00
* SHA-256: <code>82af5db3010693d98c52657dc409d723b930f7aca1dd9861cd60a3d7e6385a25</code>

WSAL19543 – SIM7600G-H-PCIE/en - Versionsgeschichte

JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex