https://wiki.jw-tech.eu/index.php?action=history&feed=atom&title=WSAL19458_%E2%80%93_SIM7600G-H-M.2%2Fen 2026-10-23T21:51:42Z Versionsgeschichte dieser Seite in JW Tech Wiki MediaWiki 1.43.9 https://wiki.jw-tech.eu/index.php?title=WSAL19458_%E2%80%93_SIM7600G-H-M.2/en&diff=2032&oldid=prev 2026-09-05T22:41:29Z

<p>Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex</p> <p><b>Neue Seite</b></p><div>__NOINDEX__<br /> &#039;&#039;&#039;Documentation notice:&#039;&#039;&#039; This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.<br /> <br /> == Summary ==<br /> The SIM7600G-H-M.2 is an M.2 B-Key module with integrated GNSS and wide band support. It supports LTE, WCDMA, GSM, and GPRS/EDGE, targeting IoT applications such as telematics, surveillance, and industrial routers.<br /> <br /> == Related products at JW Tech ==<br /> * [https://shop.jw-tech.eu/p/WSAL19458 WSAL19458 – SIM7600G-H-M.2 SIMCom Original 4G LTE Cat-4 Module, Global Coverage, GNSS, M.2 Connector]<br /> <br /> == Technical overview ==<br /> * Supported frequency bands include LTE-FDD (incl. B1–B8, B12, B13, B18, B19, B20, B25, B26, B28, B66), LTE-TDD (B34, B38, B39, B40, B41), WCDMA (B1, B2, B4, B5, B6, B8, B19), and GSM (850/900/1800/1900 MHz).<br /> * Maximum data rates: LTE up to 150 Mbps downlink / 50 Mbps uplink; HSPA+ 42/5.76 Mbps; WCDMA 384 Kbps; EDGE 236.8 Kbps; GPRS 85.6 Kbps.<br /> * Integrated GNSS systems: GPS, Beidou, GLONASS, GALILEO, QZSS.<br /> * Interfaces: UART, USB, GPIO; antenna connection via IPEX-4 (main, diversity, and GNSS antennas).<br /> * Supply voltage: 3 V to 4.2 V; approximately 4.0 V recommended for stable operation.<br /> * Form factor: M.2 B Key, dimensions 42.0 × 31.4 × 3.8 mm.<br /> * Operating temperature range: −40 °C to +85 °C.<br /> * Protocols: TCP/IP, IPv4/IPv6, Multi-PDP, FTP/S, HTTP/S, DNS; SMS in MT/MO/CB, text, and PDU formats.<br /> * Firmware updates possible via USB or FOTA.<br /> * Indicators: STA/NET LEDs indicate status (e.g., ON/OFF/blinking patterns reflect network state).<br /> <br /> &#039;&#039;&#039;Commands and examples – verify before use:&#039;&#039;&#039; <br /> &lt;syntaxhighlight lang=&quot;text&quot;&gt;<br /> sudo apt-get install minicom<br /> sudo minicom -D /dev/ttyUSB2<br /> AT+CUSBPIDSWITCH=9011,1,1<br /> sudo dhclient -v usb0<br /> AT+CNBP=0x0002000000400183,0x000001E000000000,0x0000000000000021<br /> AT+CNBP=0x0002000000400180,0x480000000000000000000000000000000000000000000042000001E200000095,0x0000000000000021<br /> AT<br /> ATE1<br /> ATE0<br /> AT+CGMI<br /> AT+CGMM<br /> AT+CGSN<br /> AT+CSUB<br /> AT+CGMR<br /> AT+IPREX<br /> AT+CRESET<br /> AT+CSQ<br /> AT+CPIN?<br /> AT+COPS?<br /> AT+CREG?<br /> &lt;/syntaxhighlight&gt;<br /> <br /> == Notes and version constraints ==<br /> * Do not plug the module while it is powered; disconnect power before insertion.<br /> * M.2 B Key is not compatible with MINI-PCIE; verify the interface before use.<br /> * Recommended supply voltage is approximately 4.0 V; operation may fail outside the 3–4.2 V range.<br /> * If the module fails to establish a stable network after setup, the listed AT+CNBP commands can adjust the frequency band – select only one of them.<br /> * Repeated dialing over NDIS may return “NO CARRIER”; set the default mode using AT+CUSBPIDSWITCH=9001,1,1.<br /> * The auxiliary (diversity) antenna requires a connected main antenna for transmission; it cannot function standalone without the main antenna.<br /> <br /> == Source and revision record ==<br /> * [https://www.waveshare.com/wiki/SIM7600G-H-M.2 SIM7600G-H-M.2 - Waveshare Wiki]<br /> * Source revision: 89868<br /> * Captured: 2026-09-01T04:19:15+00:00<br /> * SHA-256: &lt;code&gt;4d81686b2cfa9a6700944afba98683a8436a2236e6047e26189cf1ec09ebb2d0&lt;/code&gt;</div>

JWTechPublisher