JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

2026-09-05T22:35:31Z

Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

Neue Seite

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The IMX219-77IR is an 8-megapixel camera with a 77° field of view and infrared night vision, designed for Jetson Nano and compute modules. It uses a CSI interface and is tested via the associated libcamera or GStreamer commands.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL16507 WSAL16507 – IMX219-77 Camera, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL16579 WSAL16579 – IMX219-120 Camera, 120° FOV, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL16662 WSAL16662 – IMX219 Camera series, 8MP, Applicable for Jetson Nano and Raspberry Pi, Options for FOV and Night Vision function]
* [https://shop.jw-tech.eu/p/WSAL16679 WSAL16679 – IMX219-200 Camera, 200° FOV, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL16680 WSAL16680 – IMX219-160IR Camera, 160° FOV, Infrared, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL16755 WSAL16755 – IMX219-77IR Camera, Infrared, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL16974 WSAL16974 – IMX219-170 Camera, 170° FOV, Applicable for Jetson Nano]
* [https://shop.jw-tech.eu/p/WSAL18946 WSAL18946 – IMX219-160 8MP IR-CUT Camera, 162° FOV, IR-CUT Infrared, Applicable For Jetson Nano / Compute Module]

== Technical overview ==
* Sensor chip: Sony IMX219
* Resolution: 3280 × 2464 pixels
* CMOS size: 1/4 inch
* Aperture (F): 2.0
* Focal length: 2.85 mm
* Diagonal field of view: 79.3°
* Distortion: < 1%
* Lens size: 6.5 mm × 6.5 mm; housing 25 mm × 24 mm
* Interface: CSI
* Operating temperature range: 0–60 °C

'''Commands and examples – verify before use:'''
<syntaxhighlight lang="text">
DISPLAY=:0.0 nvgstcapture-1.0
DISPLAY=:0.0 nvgstcapture-1.0 --sensor-id=0
DISPLAY=:0.0 nvgstcapture-1.0 --sensor-id=1
libcamera-hello -t 0
libcamera-jpeg -o test.jpg -t 2000 --width 640 --height 480
libcamera-still -e png -o test.png
libcamera-vid -f h264 -o test.h264
libcamera-raw -o test.raw
</syntaxhighlight>

== Notes and version constraints ==
* Exact command behavior may vary by Jetson Nano firmware version; verify the version before deployment.
* If the test screen shows a reddish image, the camera_overrides.isp profile must be installed; this requires sudo rights and a connected HDMI/DP monitor.
* The combination of analog and digital gain depends on the ISP; consult driver documentation for unusual values.
* Use with Raspberry Pi 5 requires the supplied 22-pin cable; compatibility with other boards is not fully documented in the source.
* The '77° FOV' in the product name differs slightly from the parameter sheet (79.3°); confirm which value is authoritative with the manufacturer.

== Source and revision record ==
* [https://www.waveshare.com/wiki/IMX219-77IR_Camera IMX219-77IR Camera - Waveshare Wiki]
* Source revision: 108904
* Captured: 2026-08-31T03:39:56+00:00
* SHA-256: <code>b742ae6a320c4d08c8e27425f1d0ce52db9899c29e982ba1f5fd49e5119a4bb7</code>

WSAL16507 – IMX219-77IR Camera/en - Versionsgeschichte

JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex