JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

2026-09-05T22:14:10Z

Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex

Neue Seite

__NOINDEX__
'''Documentation notice:''' This technical documentation was independently rewritten from an archived supplier source. Check technical details and commands against the product version and manufacturer documentation before use.

== Summary ==
The ST-LINK/V2 (mini) is a compact in-circuit debugger and programmer for STM8 and STM32 microcontrollers. It communicates via the SWIM and SWD interfaces and connects to a PC over USB.

== Related products at JW Tech ==
* [https://shop.jw-tech.eu/p/WSAL10053 WSAL10053 – ST-LINK/V2 (mini), STM Programmers & Debuggers]

== Technical overview ==
* Interfaces: The target board uses SWIM and SWD; pins PA13/PA14 serve as the SWD programming pins.
* Connection order: Connect the ST-LINK/V2 (mini) to the PC first, then to the target board, because USB detection happens at power-up.
* Error state: If the red LED blinks continuously, the device is in an error state; unplug the USB cable or power supply and reconnect.
* Target board without power: If the target does not power the ST-LINK, short-circuit pins 2 and 19 to supply power to it.
* Keil error "illegal address (0x08000000)": Uncheck "Download to Flash" in Options for Target → Debug → Settings → Debug → Download Options.
* Keil version: For recognition failures, ensure the Keil version is at least 5.25.
* STVP software: Download from ST's official site; after agreeing, enter name and email, then follow the emailed link to download.
* ST-LINK firmware issue: Recurring connection errors can be resolved by upgrading the firmware with the ST-link upgrade utility.

'''Commands and examples – verify before use:'''
<syntaxhighlight lang="text">
Connect to the target
Program Verify
Browse
Start
Full chip erase
</syntaxhighlight>

== Notes and version constraints ==
* The exact Keil version requirement (min. 5.25) is version-sensitive; older or newer builds may behave differently.
* Short-circuiting pins 2 and 19 for power is a fallback workaround and should only be used when the target board does not power the ST-LINK.
* Holding the RESET button while clicking Program/Emulation is a manual step that depends on the specific target board.
* Chip-recognition failures may also be caused by faulty USB ports or cables; this requires physical inspection.
* Downloading STVP requires an email confirmation; the exact flow may change with updates to ST's website.

== Source and revision record ==
* [https://www.waveshare.com/wiki/ST-LINK/V2_(mini) ST-LINK/V2 (mini) - Waveshare Wiki]
* Source revision: 69184
* Captured: 2026-08-29T09:57:02+00:00
* SHA-256: <code>e785136c6b1f2ab612b3445ee8108e93b643143a59ac0975f113eabda2c2885c</code>

WSAL10053 – ST-LINK – V2 (mini)/en - Versionsgeschichte

JWTechPublisher: Freigegebene technische Dokumentation veröffentlicht; Text-only und noindex